Vegetable packing box can be seen everywhere in our life, but do you know that it also needs to be packed in the right way? The right vegetable packing box can not only protect products, but also make good use of space. The following is the packaging method and preparation before printing of the vegetable packaging manufacturer:

　　一般不同的企業(yè)都會根據(jù)產品的大小、特點定制紙箱，采用合適的紙箱包裝。但有時紙箱與需要包裝的產品不相適應，會產生較大的空隙，這時需要采取相應的解決辦法。如果縫隙沒有造成產品位置的重大變化，可以填充幾箱。蔬菜包裝盒廠家告訴你，如果紙箱內的氣孔較大，產品在運輸過程中容易發(fā)生震動和碰撞，需要用泡沫板固定。

　　Generally, different enterprises will customize the cartons according to the size and characteristics of the products, and use appropriate cartons for packaging. But sometimes the cartons are not suitable for the products that need to be packed, and there will be a large gap. At this time, corresponding solutions need to be taken. If the gap does not cause a significant change in product position, several boxes can be filled. The vegetable box manufacturer tells you that if the pores in the cartons are large, the products will easily vibrate and collide during transportation, so foam board must be used.

　　除了在加工前準備原紙和印刷設備外，還應在印刷前準備好蔬菜包裝盒，并做好技術準備，以保證印刷效果。以下是蔬菜包裝箱廠家介紹的紙箱印刷的技術準備工作。請注意。

　　In addition to the preparation of base paper and printing equipment before processing, vegetable packing boxes should be prepared before printing, and technical preparations should be made to ensure the printing effect. The following is the technical preparation work of the carton printing introduced by the vegetable packing box manufacturer. Please note that.

　　1.彩色原稿經電子分色處理成單色，然后制作成膠片。

　　1. The color originals are processed into monochrome by electronic color separation and then made into film.

　　2.用紫外線照射在印版的背面進行曝光，形成印版底座。

　　2. Use ultraviolet light to expose the back of the plate to form the plate base.

　　3.取下印版正面的保護膜，放上負片，蓋上真空膜，真空抽吸后，用紫外線作主要曝光，負片將轉移到印版上。

　　3. Take off the protective film on the front of the plate, put on the negative film, cover the vacuum film, after vacuum suction, use ultraviolet as the main exposure, the negative film will be transferred to the plate.

　　4.蔬菜包裝廠家告訴您，曬干后，用紫外線光源照射粘合劑，然后通過曝光來調節(jié)硬度。

　　4. The vegetable packaging manufacturer tells you that after drying, the adhesive is irradiated with ultraviolet light source, and then the hardness is adjusted by exposure.

　　以上是蔬菜包裝廠家為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://gwfp.com.cn

　　The above is the relevant content introduced by the vegetable packaging manufacturers. To learn more, please visit the website: http://gwfp.com.cn